Thanks to all who responded, especially to Kevin Pringge who pointed out to me the possible effects of a 33MHz bus compared to a 66MHz bus as discussed in the article at http://www.beowulf.org/archive/2001-December/005647.html which shows that performance around 30MB/s may be the practical limit on a 33MHz slot. To test the theory that a GigE interface (ge) is drastically limited when used in a 33MHz slot, I ran a test on a Blade 1500 workstation which had both a 33MHz and 66MHz slot available. The results were dramatic in that performance on the 66MHz slow was almost 2.5 times greater. The test was performed with the GE card first in the 33MHz slot which had a maximum throuput of ~35MB/sec. When the card was moved to the 66MHz slot, I was able to achieve ~80MB/sec, which is about what I was expecting for a gig connection. The following is the output from the TTCP bandwidth testing tool: GE Interface in 33MHz slot: java ttcp -t 10.0.101.240 -n 65536 Transmit: buflen= 8192 nbuf= 65536 port= 5001 Transmit connection: Socket[addr=10.0.101.240/10.0.101.240,port=5001,localport=64869]. Transmit: 536870912 bytes in 15142 milli-seconds = 35455.746 KB/sec (283645.97 K bps). GE Interface in 66MHz slot: java ttcp -t 10.0.101.240 -n 65536 Transmit: buflen= 8192 nbuf= 65536 port= 5001 Transmit connection: Socket[addr=10.0.101.240/10.0.101.240,port=5001,localport=64849]. Transmit: 536870912 bytes in 6676 milli-seconds = 80418.055 KB/sec (643344.44 Kb ps). Further to this, I was able to find a SunSolve document titled "Sun[TM] GigaSwift Ethernet (ce) performance slow." (DocID 81991) which did reveal an interface kernel counter 'rx_ov_flow' incrementing. A sign that the 33MHz slow is potentially the problem. Once again, thanks to those who responed. Original question below. Peter > -----Original Message----- > From: Hackett, Peter > Sent: Friday, November 04, 2005 12:06 PM > To: 'sunmanagers@sunmanagers.org' > Subject: Slow Network Performance On V880 > > > Good Day, > > I have a Solaris 9 V880 NFS server w/4 X 900MHz CPU's and 8GB > of Memory. It's configured with 5 HBA's for various disk and > SAN connectivy, and a CE interface (@1000FD) for network > connectivity. The problem I'm experiencing is that I cant > seem to get more than 30 MB (240Mbps) through the network > interface where I am expecting around 85MB (680Mbpb). I'm > using TTCP and simply FTP to measure. I am trying to find > where the problem lies and where the bottleneck is. What > I've looked at so far is SE-Toolkit's nx.se which indicates 0 > Coll%, 0 NoCP/s, and 0 Defr/s, and I've looked at nicstat > (from brendangregg.com) which also show very low utilization > and zero saturation. I also did a switch from ge to ce to no > avail. So, this leaves me with the though that maybe there's > not enough CPU resources to drive all this I/O, but CPU's > typically don't run greater than ~70%, with %sys not much > greater than 25% or so, which is where I though I would see > problems if CPU was the factor. Anyway, I'm looking for how > I determine where and why my network throughput is about a > third of what it should be? What metrics / tools can I use to > isolate and pinpoint the bottleneck? Any and all help and > insight would be appreciated. > > Peter _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Mon Nov 7 15:07:15 2005
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:52 EST