This was exactly the issue. I did a set-defaults and a reset-all from the OBP and it has continued with the jumpstart. Thanks to all who responded Andy -----Forwarded Message----- From: Joe Kabbabe <jkabbabe@svtr.com> To: Andy Ford <andy.ford@telindus.co.uk> Subject: RE: failed to boot after jumpstart ?? Date: Thu, 17 Jun 2004 11:00:42 -0700 At the OK> prompt, type 'printenv' and if the value of 'diag-switch?' is true, then check the value of 'diag-file'. If the value of 'diag-switch?' is false, then check the value of 'boot-file'. Try 'set-defaults', then 'reset-all'. Joseph Kabbabe Sun Valley Technical Repair, Inc. Specializing in Purchases - Sales - Repairs SUN * IBM * Cisco * Hitachi 15555 Concord Circle, Morgan Hill, CA 95037, USA Tel: (408)825-1736 Fax: (408)825-1636 Yahoo IM: joeksvtr AOL IM: joeksvtr -----Original Message----- From: Andy Ford [mailto:andy.ford@telindus.co.uk] Sent: Thursday, June 17, 2004 4:33 AM To: sunmanagers@sunmanagers.org Subject: failed to boot after jumpstart ?? Hi everyone I am trying to jumpstart a V120 with Solaris 9 4/04. The jumpstart gets as far as the finish script, it then reboots and comes up with the following message.... ------------ Rebooting with command: boot Boot device: disk:a File and args: "" boot: cannot open "" Enter Filename [""]: ----------- What am I missing? And which file is it looking for? Thanks Andy _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Fri Jun 18 01:58:41 2004
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:32 EST