Many thanks for all the replies, it turned out that the problem was due to two faulty hardware components - one of the new disks that I was inserting and the controller tray on the A1000. Once these had been replaced then the problem disappeared. Many thanks to everyone that replied with suggestions. Kev -- Kevin Davidson | UNIX Systems Administrator Transaction One | www.transaction-one.com 020 8358 9126 | kdavidson@transaction-one.com -----Original Message----- From: Kevin Davidson Sent: 04 June 2003 14:47 To: sunmanagers@sunmanagers.org Subject: Cannot access A1000 via RM6 Gurus, I have created a new LUN on an A1000 array. However, when I try to access the array via either the RAID Manager 6 GUI or the command line tools, I get the message "Unable to Scan Module". I have worked through all the steps in the Recover Guru - rebooted the host, run the "clean" application, etc, but am still getting the same result. Sun support have suggeested that there is a problem with the controller and I will have to rebuild the entire array. Any other suggestions? Will summarize. Thanks, Kevin -- Kevin Davidson | UNIX Systems Administrator Transaction One | www.transaction-one.com 020 8358 9126 | kdavidson@transaction-one.com _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Fri Jun 6 06:33:13 2003
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:12 EST