The resolution settings on my framebuffer were not supported by my PC monitor. I ended up using m64config to change them. On a remote terminal (as root), I did the following: m64config -res 1280x1024x75 try I would like to thank the following people for their replies: Ric Anderson <ric@Opus1.COM> Hichael Morton <mh1272@yahoo.com> On Tue, 1 Apr 2003, George P. wrote: > Hi all, > > How do I attach a PC monitor to an Ultra-10 running Solaris 2.7? (monitor > model is 18" NEC/Mitsubishi LCD1850E LCD Flat-Panel Display 1280x1024) > > I connected the PC monitor to the SUN PCI card, but the computer doesn't > "see" it until I physically remove the SUN Creator 3D graphics card. Is > there a way to be avoid the removal of the SUN graphics card? After > removing the SUN card, the SUN booting messages appear properly on the PC > monitor, but right before the system is up, I get the following warning: > > Warning: There are no 'nf' devices plumbed and up > Unable to start NF FDDI SMT/SNM daemon. > Warning: There are no 'pf' devices plumbed and up > Unable to start PF FDDI SMT/SNM daemon. > > Also, when I try to load openwindows, the screen flickers and at that > point I just have to kill the process remotely. > > Also, how do I attach a PC monitor to an Ultra-5 running Solaris 2.7? > > Thank you very much for your input. Please, let me know if you need me to > provide additional info. > _______________________________________________ > sunmanagers mailing list > sunmanagers@sunmanagers.org > http://www.sunmanagers.org/mailman/listinfo/sunmanagers _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Tue Apr 1 21:06:50 2003
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:08 EST