Thanks everyone who responded - here is what I did so far 1. installed ce drivers 2. installed 111883 patch 3. shutdown system and installed card in slot 5 (bus A) - this is on the same bridge as the other PCI bus that has onboard SCSI and hme0. We have A1000s on other buses. 4. boot -r 5. ifconfig ce0 plumb made sure ce0 is listed in ifconfig -a things to do once I have the cable ready from network team: add entry to /etc/hosts; create /etc/hostname.ce0 add entry to /etc/netmasks setup routing for the backup LAN using a "route add net" command. Also make a inet.d script that adds router entry upon reboot. ifconfig ce0 ...... up I was told that ndd commands should not be added to /etc/system. Hence I plan to make another inet.d script in /etc/rc2.d which has ndd commands (if needed). ----- Original Message ----- > We are installing a second NIC on our E450 running solarais8. The onboard > NIC is used for regular network and this gigabit card will be used in a > backup LAN for doing nightly backups. The user manual talks about > installing drivers > installing the card > boot -r > set up /etc/hostname.ce0 and make entry to /etc/hosts > make entries to ce.conf (like if we need auto negotiation off etc) > reboot again > > I also learnt there is a patch I need to install at some point (111883). > > Question is, is that all? > The IP number I received is in a different sub-domain (understandably) and > also differnt netmask (255.255.248.0 vs the onboard NIC's 255.255.255.0). > Its gateway is also different from the one in /etc/defaultrouter > Where would I enter the different netmask and gateway info? > > thanks > SS _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Tue Feb 25 12:38:18 2003
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:04 EST