Ok, further thanks to: "Riddoch, John E SITI-ITDSEP3" <John.E.Riddoch@is.shell.com> Joon Martin Hansen <joon.martin.hansen@eterra.no> Al Hopper <al@logical-approach.com> "Mortensen, Henrik" <henrik.mortensen@csfb.com> Peter Stokes <peter@ashlyn.co.uk> "Sharpe, John" <John.Sharpe@vuinteractive.com> Jay Lessert <jayl@accelerant.net> The deal is, not only do you need to check jumper J3001, but a certain rev of the OBP is required, as well as a certain rev of the motherboard. What we ended up doing was just swapping the hard drives in the machines. This worked, thankfully. Check http://sunsolve.sun.com/handbook_pub/Devices/CPU_Module/UltraSPARC_400MHz_UltraII.html for more details. -Adam On Tue, 9 Jul 2002, Adam and Christine Levin wrote: > > Thanks to: > Charles Rawls <crawls@tgix.com> > Paul Galjan <galjanpa@cmr.gov> > "Moore, L. Bryan" <lbmoore@scrippsops.com> > > There's a jumper, J3001, that needs to be switched for the CPU speed. > > However, when I switched it and installed the 400MHz, the OBP banner > reports 250MHz. > > I wonder if this system is too old to make use of a 400? Any additional > thoughts? > > One response said that you need minimum: > CPU board 501-3132-13 > POST > 3.3.8 > OBP > 3.12 V10 > > -Adam > > On Tue, 9 Jul 2002, Adam and Christine Levin wrote: > > We're currently moving some hardware around, and I've got two E250s open > > on the floor of the systems room. We swapped 2x300MHz UltraSPARC II procs > > out of one and into the other. The other had 1x400MHz UltraSPARC II. The > > first system refuses to boot with the 1x400 -- it boots fine with 2x300, > > but when I swap in the 1x400, the power comes on, the drives spin up, and > > nothing else happens. > > > > Thoughts? > > > > -Adam _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Wed Jul 10 18:38:34 2002
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:42:49 EST