SUMMARY: temperatures on E10k

To sum it up: it's a wanted feature.

As an sun engineer explained to me, the values reported by hostview -t are
only updated if they exceed a certain difference - he said two degrees
celsius.

So my constant values state only, that the airconditioning keeps the
temperatures below this difference limit.

> -----original posting-----
> Von: Schlaich, Florian [mailto:Florian.Schlaich@Dresdner-Bank.com]
> Gesendet am: Dienstag, 22. Mai 2001 18:32
> An: 'sunmanagers'
> Betreff: temperatures on E10k
> 
> Hello out there,
> 
> i've just started monitoring the temperature info provided by 
> hostinfo -t.
> The temperatures are specified with up to 3 digits following 
> the decimal
> point (e.g. milli Kelvin).
> But: my log with an stepping time of 15 minutes over 20 hours 
> showed NO
> change for all temperatures except the 5V DC on the systemboards.
> 
> Has anyone out there done this, and seen same/different results?
> 
> If it matters: SSP SW is 3.4, installed are 7 systemboards on 
> back (none
> fully equipped), hostview reports same values.
> 
> Any comment would be appreciated
> 	Florian Schlaich
> Schlaich Messtechnik Consulting            | Dr.-Ing. Florian Schlaich
> Consulting for measurement apps in the lab | 
> and for highly available unix systems      |
> mailto:f.schlaich@messtechnikconsulting.de
> Tel. +49 7151 46880                        | 
> FAX: +49 7151 947650                       | cellular: +49 172 7359635
> Schopenhauerweg 5                          |
> D-71332 Waiblingen                         |
> http://www.messtechnikconsulting.de        |
> 
> currently working at mailto:Florian.Schlaich@Dresdner-Bank.com
> 
> _______________________________________________
> sunmanagers mailing list
> sunmanagers@sunmanagers.org
> http://www.sunmanagers.org/mailman/listinfo/sunmanagers
>