My post:
>I have a HP DesignJet 755CM (C3198B) plotter plugged into the >network.
>It's spooler is a Solaris 2.5.1 machine. I've set it up with >Jetadmin
>6.02.
>
>It prints, but AutoCAD prints are pushed off to the side of the roll.
>The last part of the AutoCAD figure ends up on the next page. Also, >it
>advances a lot (wasting lot of paper) before printing each time.
Thanks to
<dharringt@deq.state.va.us> (David B. Harrington)
>You might try going to HP's website and search for drivers. Or check >the
>AutoCad folk's website.
>
>I got the same printer(!) which is connected thru TCP/IP to my Sun
> >network, and several Windows NT machines. I get all sorts of wierd
> >problems with this
>arrangement, but their HP's wesite is helpful.
>
>Dave Harrington
>VA Dept of Env Quality
>Voice: 804-698-4558
>FAX: 804-698-4561
The paper advancing was fixed by setting the print area to the inked area.
The plots printing on the side were fixed by adjusting the offset in the
software.
Thanks!
SD
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:14:03 CDT