I reseated the card and ... Success! Thanks Barry!
-------------------------------------------------------------
My original message:
Managers,
I am having difficulty setting the console for a SS20 running 414. At
first I believed the problem to have been settings in the eeprom environment
but after much help from the list I reset to the defaults. With two
graphics ports (the onboard and an sbus add-on) I still have no video on
either. Again, I've been through the FAQ and the man pages and Manual
without luck.
dmesg reports a strange message:
No default frame buffer found
How can I set a default?
Should I just pull the second frame buffer?
-------------------------------------------------------------
Response:
> No. Unless you have a Video Memory SIMM, the on board video will not work.
> Try re-seating the SBus video card. Also make sure you are using a good
> monitor (plug it into a sparc you know is working). If that all fails, you
> probably have a bad video card.
-- -=( Paul Wood http://pobox.com/~paul.wood)=- -=( paul.wood@pobox.com Temple University Network Services)=-
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:13:34 CDT