Sun Managers:
Thanks for all the replies:
There is a doc in the answerbook for Ultra h/w setup describing the
parameters to set for full duplex operation:
1) Driver dependent config (/kernel/drv/hme.conf):
-- ------ --------- ------ -----------------------
adv_autoneg_cap = 0 adv_100fdx_cap = 1 adv_100hdx_cap = 0 adv_10fdx_cap = 0
adv_10hdx_cap = 0;
2) /etc/system config:
-- ----------- -------
* Begin hme - force 100BaseTX - Full Duplex Mode
set hme:hme_adv_autoneg_cap=0
set hme:hme_adv_100hdx_cap=0
set hme:hme_adv_100fdx_cap=1
* End hme
3) ndd config setting:
-- --- ------ --------
ndd -set /dev/hme adv_autoneg_cap 0
ndd -set /dev/hme adv_100hdx_cap 0
ndd -set /dev/hme adv_100fdx_cap 1
So far I have had no problems using Full Duplex 100BaseTX mode on my
Ultra Creator 1 with Bay's 28115ADV 10/100 switch, agent software
version 2.012.
How to check what mode and speed a hme adpater is current running at:
---------------------------------------------------------------------
sunbay:/# ndd /dev/hme link_speed
1 1 - 100MB/sec
sunbay:/# ndd /dev/hme link_mode
1 1 - Full Duplex Mode
Note: When you do a 'netstat -i' you should notice that the collision
count should be zero...
Orginal Question:
-----------------
>Sun Managers:
>
>I have a hme adapter on a ultra creator 1 machine. How do I force
>100BaseTX Full Duplex mode using the ndd command or setting a driver
>variable in /etc/systems....
>
>I would like to run in Full Duplex mode with a Bay Networks 28115
>switch...
________ __ __ __ __
/\_\_\_\_\ /\_\ /\_\ /\_\ /\_\
/\/_/_/_/_/ /\/_/ /\/_/ /\/_/ /\/_/ Ronald W. Henderson
/\/_/__\/_/ /\/_/ __ /\/_/ /\/_/___/\/_/ SUNY-Albany
/\/_/_/_/_/ /\/_/ /\_\ /\/_/ /\/_/_/_/_/_/ (518) 442-4571 Phone
/\/_/ \/_/ /\/_/_/\/_/_/\/_/ /\/_/ /\/_/ (518) 442-5825 Fax
\/_/ \/_/ \/_/_/_/_/_/_/_/ \/_/ \/_/ rwh@atmos.albany.edu
--------------------------------------------------------------------
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:11:51 CDT