SUMMARY:How to transfer data from 8mm to 4mm DAT

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all

Thanks to everybody.

The Solution is
Connect the two tape drive on same SCSI controller and use the tcopy command.

tcopy <Source drive > < Destination drive >

Thanks and Regards,
Umesh

> From sun-managers-relay@ra.mcs.anl.gov Wed Feb 5 10:33:09 1997
> Sender: sun-managers-relay@ra.mcs.anl.gov
> From: Umesh Shrikrishna Potbhare <upotbhar@cvimail.cv.com>
> Reply-To: Umesh Shrikrishna Potbhare <upotbhar@cvimail.cv.com>
> Followup-To: Umesh Shrikrishna Potbhare <upotbhar@cvimail.cv.com>
> Date: Wed, 5 Feb 1997 20:37:32 +0500
> To: sun-managers@ra.mcs.anl.gov
> Subject: How to transfer data from 8mm to 4mm DAT
> X-Sun-Charset: US-ASCII
> Content-Length: 324
> X-Lines: 11
>
> Hi all,
>
> I have 8mm DAT tape cartridge and I would like to transfer it on 4mm DAT tape. The data on 8mm is in dd format compressed using gzip.
> And I would like to transfer all the containt of 8mm to 4mm.
> Donot know how many blocks are there in 8mm tape.
>
> Please guide.
>
> Thanks and Regards,
> Umesh
> ComputerVision ( Netadmin)

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:11:44 CDT