Thank you all:
Steve Gray <sagray@amp.com>
John Rosenberg <jcr@bgumby.bwh.harvard.edu>
Bismark Espinoza <bismark@alta.jpl.nasa.gov>
gary@ranchogrande.mce.com
John Justin Hough <john@oncology.uthscsa.edu>
charles.mengel@lgi.com
Original Post:
> I was just passed down an old HP 7580 Pen Plotter (D size) with the
basic
> cables that were used to connect to a PC. Now, I'm planning to connect
> this plotter to a SS10 on 4.1.3_U1. What are the necessary equipments
> needed for my connection to be successful (eg. connectors, other
cables).
> Thank you. Will summary
Answer:
Cable: RS-232 null modem cable via serial port (ttya or ttyb) is the
popular choice. However, parallel port also can be used with a parallel
cable.
Switch settings on plotter:
INTERFACE MODE: RS-232-C
Dip switches:
EXPAND --X NORMAL
EMULATE --X NORMAL
STAND ALONE X-- EAVESDROP
MONITOR MODE --X NORMAL
LOCAL --X NORMAL
PARITY ON --X OFF
OFF --X ODD
DUPLEX-HALF X-- FULL
HARDWIRE X-- MODEM
DTR BYPASS X-- NORMAL
BAUD RATE: 9600
Sample printcap entry:
hp7580|hp7580| HP pen plotter:\
:lp=/dev/ttyb:\
:mx#0:sh:\
:br#9600:\
:sd=/usr/spool/hp7580:\
:st=/usr/spool/hp7580/status:\
:lf=/usr/spool/hp7580/errorlog:
**************************************************i*********************
* Thang Victor Dinh | Email: tdinh@irvine-sensors.com *
* Engineering Network Administrator | Phone: (714) 444-8770 *
* IRVINE SENSORS CORPORATION | FAX : (714) 540-6712 *
***********************************************************************
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:10:55 CDT