My original question was:
>
> Folks --
>
> I am having great difficulty getting the Ross HyperSPARC single CPU 90MHz
> model working in a SS10 (Model 30). It dies in one of 2 ways -
>
> 1 - Hard hang - it just hangs and must be powered off.
> 2 - Panic: cpu0, then reboots
>
> I have installed 2 seperate modules with the same results. The system
> runs 4.1.3 and DBE 1.3 and Informix. I have installed the jumbo kernel
> patch only. Of course, the Ross patches have been installed.
>
> Any ideas would be greatly appreciated!
Thanks to those who replyed:
Carlo Musante
Aline H. Runde
Rich Schultz
Rick (rnf)
Well --
Things are okay now, but I am somewhat uneasy about the current state
the systems in question. Here is how we stand...
After a mother board change in the original system, the situation got worse -
in would crash within 5 minutes. Ross had no other concrete idea, so we
put the Ross module into another SS10 to test, and it has worked for
5 days without so much as a hiccup.
This, of course, doesn't make us feel completely better, since we haven't
installed it into the production system, our ultimate target.
Will the production system react like system #1 or system #2???
Most of the suggestions people made concerned the jumper changes needed
on the mother board - we made those to no avail. Aline mentioned the PROM
version. we had the current version of 2.19.3
So we have a decision to make....
Thanks again to the Borg-like creature we call "sun-managers"!!!
============================================================================
|Charles Mengel |
|Systems Eng Manager | ________________
|LGI | | _____ _ |
|9017 Red Branch Rd | |/ \ * / / |
|Columbia Maryland USA 21045 | \ | | |____
|VOICE 410-997-1393 | \ | | |
|FAX 410-720-1241 | |_| | /
|EMAIL charles.mengel@lgi.com | \___|
=============================================================================
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:10:25 CDT