As I have received many request for this information I decided to post rather than try to reply to all the many people who asked.
This is from a FAX I received from Toshiba.
"XM-3401B drives have a multi-firmware enhancement feature. This will allow
production to select one of 4 different firmware configurations supplied with
the drive per specific customer requirement.
The options are:
0 Toshiba standard configuration (default condition)
1 512 byte block length configuration (2048 is standard)
2 SGI Version
3 Intergraph/Sun Micro configuration
These options are selected by opening certain etch(s), Fig. 1, between pads
shown in Fig. 2. If requirements change or etches are cut in error, solder
a small wire between the appropriate pads to obtain the desired configurtation.
Fig. 1;
0 1 Selected Version
Connect Connect Toshiba Standard Version
Connect Cut 512 Byte Block Length
Cut Connect SGI Version
Cut Cut Intergraph/Sun Micro
Fig. 2;"
|----------------------------------------------------------|
| |--|
| | | DC POWER
| | |
| |--|
| |
| |--|
| TOP | REAR
| | |
| | |
| | | Signial Cable
| | | Connector
| | |
| |--|
| |
| |-|
| |-|
| 0 |-|
| 1 |-|
| |
|----------------------------------------------------------|
My artistic ability does leave something to be desired.
Dave
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:07:54 CDT