The original query was:
I have seen this problem both on a SPARC, and a NCD Xterminal
connected to the same SPARC. The tools run correctly but typed
text in the command window of the tool is not displayed.
Obviously echo is turned off for the pseudo tty being used for
the command window but what needs to be done to ensure it is
always turned on?
firstname.lastname@example.org (Maria A. Barnum)
email@example.com (Fred G. Kuhns)
Maria had the solution that will always work, add this line
to your .dbxinit file:
sh stty sane
Works on the SPARC under the circumstances where it previously
failed. It also works on the Xterminal.
Craig Bishop Information Systems Division
Email: firstname.lastname@example.org Geelong & District Water Board
Phone: +61 52 262506 61-67 Ryrie St Geelong
Fax: +61 52 218236 Victoria 3220 Australia
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:07:52 CDT