I'd like to thank all of you that answered.
The question was:
>can I use a SBus Prestoserve Acceleretor in a MP670 or I must get a VME-bus
>Co-Processor?
--------------------------------
From: reardon@sws.sinet.slb.com (Bob Reardon Maildrop 3F - x4794)
The NC400 coprocessor and the Prestoserve can both be used with
Sparc 670MP. The NC400 goes in a VME slot and Prestoserve uses
an Sbus slot. Only one Prestoserve is needed and it accelerates
all disk *WRITES* for the system, even if there are more than
one disk controllers. The NC400 accelerates *READS* and has an
ethernet connector. After it is installed, your ethernet cable
connects to the NC400 rather than the le0 (lance). If your 670MP
is a router for 2 IP networks and you want to accelerate both
networks, then you need two NC400 boards.
--------------------------------
From: kalli!kevin@fourx.aus.sun.com (Kevin Sheehan {Consulting Poster Child})
Purely speculation, but I suspect the SBus card will be the proper choice.
I also suspect that porting the Prestoserve drivers over is not complete
yet...
--------------------------------
From: ray@isor.vuw.ac.nz (Ray Brownrigg)
I just read something in one of the Sun newsgroups which indicates that an
Sbus Prestoserve is fine for SCSI devices, but you need a VME-bus version
if you want to accelerate VME devices (IPI disks etc).
--------------------------------
From: Mike Raffety <miker@sbcoc.com>
My understanding is that you can use either, but you'll get best results
if you match the bus to your disks; if you've got an SBus SCSI board,
use an SBus Prestoserver, if it's VME or SMD or a VME SCSI controller,
use the VME board, though either should work.
-- Simon Shickman simon@horizon.huji.ac.il Computation Center voice: +972-2-584279 The Hebrew University of Jerusalem fax: +972-2-527349 Jerusalem 91904, ISRAEL bitnet: simon@hujivms
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:06:40 CDT